신고사유
신고해주신 내용은 쇼핑몰 운영자의 검토 후 내부 운영 정책에 의해 처리가 진행됩니다.
상품명 | GOLDEN AGE - FC3 |
---|---|
판매가 | 284,000원 |
브랜드 | GOLDEN AGE |
상품간략설명 | 클래식 스타일의 듀얼 캡슐 콘덴서마이크 입니다. |
배송비 | 2,500원 (50,000원 이상 구매 시 무료) |
수량 |
월 렌탈 금액 |
월 원 (개월 기준)
|
---|
구매방법 | |
---|---|
배송주기 |
정기배송 할인 save
|
옵션선택 |
(최소주문수량 1개 이상 / 최대주문수량 0개 이하)
사이즈 가이드할인가가 적용된 최종 결제예정금액은 주문 시 확인할 수 있습니다.
The FC 3 is a side-address, 3-pattern FET condenser with a transformer-coupled output circuit.
Although previously reported here (based on statements from GAP) to use a 34mm, 3-micron capsule, the sample FC3 microphone we purchased contained a 32mm capsule. This capsule almost certainly has a 6-micron diaphragm. It is a center-terminated K67 type.
Three switches on the mic body enable pattern selection (Cardioid, Omni, Figure-8), a switchable pad (-10dB), and a switchable high-pass filter (cutoff at ~80Hz).
The circuit is a two-stage transistor design, with an emitter follower driving a low-ratio output transformer. This circuit is linear — it does not apply any frequency-dependent corrective filtering to the capsule’s signal, unless the high-pass filter is engaged.
The DC circuit board contains a voltage multiplier that is capable of polarizing the capsule at +60VDC. Individual samples we’ve seen vary from 50–63VDC. Note that in Figure-8, the rear diaphragm is at double this voltage (+120V), while the backplate is at +60.
The FC3 is nearly identical to the CAD GXL3000, although the GXL3000 comes with a higher-quality, larger capsule (35mm O.D., 6 micron diaphragms).
The Golden Age Project FC 3 is also known as: FC 3.
Pickup Patterns | Pads & Filters |
---|---|
Omnidirectional (14.5 mV/Pa; 20 - 20,000 Hz) Cardioid (14.5 mV/Pa; 20 - 20,000 Hz) Bidirectional (14.5 mV/Pa; 20 - 20,000 Hz) |
|
Capsule Dimensions | Impedance | SPL/Noise |
---|---|---|
Diaphragm diameter: 25mm Capsule diameter: 32mm Diaphragm gauge: 6 microns | 250 Ohms (Low) | Max SPL: 140 dB Self-noise: 17.0 dB(A) |
Weight | Length | Max Diameter | Interface(s) |
---|---|---|---|
470g (16.58oz) | 190mm (7.48'') | 50mm (1.97'') |
|
Power Specifications |
---|
|
The GAP FC3 combines a linear circuit with a peaky 32mm K67 capsule type. The result is a not flattering to most sources, creating sibilance on vocals and fatigue on most everything else.
We offer two modification options for this mic.
The stock GAP capsule is a typical 32mm K67 type, found in just about every inexpensive large-diaphragm condenser microphone on the market. It has a peaky and uneven response that is not very musical, and tends to require EQ to fit into a mix.
We recommend replacing it with a K47 type, which will give a more neutral top-end response, with rich midrange detail. Our favorite capsule for this mic (assuming the stock circuit is retained) is the RK-47.
Another option is our RK-12. The voicing of this capsule is bright, but it sounds different than the stock GAP capsule; it has a smoother top-end response and warmer lows. It excels for female vocals.
The FC 3 circuit is a 2-stage transistor circuit with an "emitter follower" and a low-ratio output transformer. We don't care much for the design; the 2nd stage transistor seems to clip under moderate SPL, and the transformer is not adding any sonic value.
We've developed a version of the KM84 circuit, which is a linear single-stage JFET design with a very high-quality output transformer. We designed custom circuit boards for this circuit, to make room for the best-quality parts we could find. Customers say the results more than justify the cost.
글읽기 권한이 없습니다.
"19세 미만의 미성년자"는 출입을 금합니다!
번호 | 카테고리 | 제목 | 작성자 | 작성일 | 조회 |
---|---|---|---|---|---|
공지 | 문의사항 더 빠르게 답변 받는 방법 | MySoundMall | 2016-10-31 16:06:14 | 21431 |